User manual

Replacing a Source
399
© 2014 Digital Vision
UM-2014.1-07
Command :
$ film_master --project PROJ1 --composition COMP1 \
--replace-source M:\images\shots\009\056_009.001.dpx \
--record-in 100
INFO Opening project "PROJ1".
INFO Opening composition "COMP1".
INFO Found range (1, 54).
INFO Set clip name to "VERSION2".
INFO Clip added to composition.
The source will be replaced.
Grades will be retained on the shot.
You need to have at least the same amount of source material in the
new version as the old or an error will occur.
Splice and Overwrite Clips
--splice [path]
Splice a clip to the composition timeline
If clip path not given, clip name must be.
--overwrite [path]
Overwrite a clip to the composition timeline.
If clip path not given, clip name must be.
--record-in <N>
Composition timeline record position
--source-in <N>
Input clip source position offset
--name <name>
Select name of library clip to operate on
--length <N>
Consider only this number of input frames
--track <Vn>
Select video track to operate on
Splice versus Overwrite
A splice operation will push any existing clip frames up the timeline
from the splice location.
An overwrite operation will overwrite any existing clip frames from
the splice location.
If a clip file path is not supplied, it is required to supply a clip name (
--name). If you only supply a clip name, it must exist in the project
library.