User manual

Video I/O

378

UM-2014.1-07

Output Single

This button is enabled whenever a single event is selected/highlighted in the

event list. Pressing it will layoff that specific event only.

Stop Output

This button is only enabled when there a layoff is in progress. Pressing it will

halt the layoff.

Output List

will layoff the entire event list.

Checking the List

Before the list is output to video, the events are first checked to ensure they

are fully rendered and available.

Validate Output

Default : On

If Validate Output is enabled, a final output validity check is performed after

any rendering is complete.

Once layoff starts, the button will turn red and the

Stop O utput

button will

become enabled and turn green.

The tape will be scanned for the correct timecode in-point and recording will

commence. For a crash record, recording will commence at the tape position.

All the events shown in the event list will be written to tape.

The layoff can be halted at any time by pressing the

Stop O utput

button.