User manual

Video Layoff

377

UM-2014.1-07

Pad Events controls whether padding is to be applied during output. Padding

consists of black frames with contiguous timecode being written before and

after the events being laid off.

How much padding is written is controlled by the In and Out timecode fields.

The timecode given to the padding will always precede the timecode

of the 1st event being laid off, and if a Mark-In Timecode has been

supplied the timecode of the padding will precede the Mark-In TC.

Padding can only be carried out in Crash Record mode.

In / Out Markers

The In, Out and Duration boxes relate to the in, out and duration times of your

event list. Record timecodes or source timecodes are used according to the

Timecode Output Order selected.

You can set the In point timecode by :

Pressing the Set In button (Cue In). This sets the In timecode to the

current deck position.

Erasing and typing in a new timecode via your keyboard.

Use mark as in point

Ticking this box will set your layoff in-point to the In timecode set. Your list

will be recorded starting at this In timecode

Output List

This button is enabled when there are events in the event list. Pressing it will

start off the layoff to tape of all the events in the list.

Unlike the VTR Capture module, you cannot select a group of events

for layoff from the event list. All items in the list will be output. To

select a sub-section for layoff, see Laying Off Sections.