User manual

Video I/O
376
© 2014 Digital Vision
UM-2014.1-07
Timecode Output Order
This drop-down list allows you to select which timecode order is to be used
when writing the events to the tape:
Source Order TC (C)
Record each event to tape at its original location (i.
e. its source timecode), ignoring its location on
the composition timeline (record timecode).
Event handles : enabled.
Source Order Tape
(C)
This is the same as Source Order TC except the
list is sorted by tape first, then source timecode.
Event handles : enabled.
Record Order (A)
Record each event to tape at its composition
(record) timecode location i.e. the same
sequential order as your composition timeline and
at the same timecodes (unless "Use mark as in
point" is set, see below).
Event handles : disabled.
Event Handles are enabled for Source Order mode layoffs :
Note that Source Order layoffs will not render transition effects.
When Source Order is selected, the Mark-In/Out values in the Event
List will change to show the source timecodes matching the start
and end timecodes of the list events. When Record Order is
selected the record timecodes are shown instead.
Pad Events In / Out
Crash Record only.