User manual

Video Layoff
375
© 2014 Digital Vision
UM-2014.1-07
Record Edit Mode
This drop-down list allows you to select the edit mode, which determines how
material is written to tape. The following modes are available.
Insert Edit
Each event is recorded at the record in-point timecode.
This mode requires a tape pre-striped with the right record
timecodes.
Assemble
Edit
This locates the record in-point timecode of the first event
and starts recording. From here, timecodes are generated
(assembled) as the output proceeds. Only the initial in-
point timecode is required (hence only a partially striped
tape is necessary).
Crash Record
This method starts recording at the current tape position,
with no pre-roll or post-roll used, and writes out timecodes
as it records. This mode will therefore work on a blank
tape (no pre-striping required) and is only suitable for
laying off contiguous material.
The Pad Events option is available here.
Preview BVB
This mode previews the output. It does not write anything
to tape.
The preview shows : Black - Output Video - Black.
Preview VVV
This mode previews the output. It does not write anything
to tape.
The preview shows : Video - Output Video - Video.
Review
This mode reviews the output on tape. It does not write
anything to the tape.
Pre-striped tapes must be striped at the same frame rate as your
composition.
The Actions buttons will change depending on record mode selected.