User manual

Video Layoff
373
© 2014 Digital Vision
UM-2014.1-07
in Source Order.
Material
This column shows the location of the rendered material on disk. This may or
may not correspond to the location of the source material shown in the library
screen.
Tape Name
This column shows the tape name corresponding to the source material for
that event.
Event Handles
If a source order mode (e.g. Source Order Tape) is selected, the Event
Handles option is enabled.
This numeric slider is located directly below the event list, and allows the
option of laying-off more frames than each event requires (i.e. adding
'handles'). The handles are added on either side of the event on tape.
The addition of handles might be applied in order to layoff as much of
each media clip as might be later needed when re-importing the
media as source material for a composition, and to allow later
trimming of the media clip within the composition.
Laying off Sections
With no marks set, the Output module will select all events for layoff.
To layoff a section of your timeline only, use the timeline Mark In and Mark
Out buttons to mark the desired range before pressing ..List O utput .
The output module will only display and output the marked events.