User manual

Video I/O
368
© 2014 Digital Vision
UM-2014.1-07
Material
Once an event has been captured (Found), the path to the stored media will
be shown in the Material column for that event.
Tape Name
Events in the list may need to be captured from different tapes, as indicated
by the Tape Name column. You will be prompted to insert each tape (or to
skip it).
This will continue until all the media from the different tapes has been
captured.
If you press Skip T ape , no media will be captured for this tape and
capture will proceed to the next tape (prompt for insert), if there is
one. You can capture any skipped tapes later.
Event Controls
The event controls, located beneath the event list, allow you to refine your list
and select specific events prior to capturing:
Enable / Disable Event
To selectively choose to capture events (or not), select single or multiple
events from the list and use the Enable Event and Disable Event
buttons prior to pressing Capture List .
A disabled event will have a status that displays Disabled e.g. Disabled
(Needed) or Disabled (Found).
You can capture events in "groups", perhaps using a different
number of handles for each.
Reset Event
This option will reset the selected event(s) to the status of Needed, whether or
not the media had already been captured. This allows a re-capture of a
previously captured event.