User manual

Video I/O
360
© 2014 Digital Vision
UM-2014.1-07
Use 5.00 FPS (4K)
Blanking
VTR Output only
This setting will blank out the top and bottom video lines.
This may be useful to hide any edge artifacts pushed into the video
active area by certain effects (e.g. blurs).
Audio I/O
Note - the audio settings on the right are only available in the Capture module.
The audio channel buttons give feedback and also act as controls. They will
automatically default to show how many audio channels are available
(highlighting them in green), after which you can enable/disable them for
capture/layoff.
2014.1 currently supports eight (8) channels of audio. The buttons
for channels 9-16 are visible but disabled (and not used).
Capture Only
Interface
Options : AES-EBU or Embedded SDI
This sets the source of the captured audio data.
We support AES/EBU audio with the Bluefish Lust card (AES audio cables)
We support AES/EBU and embedded audio on the DVS Centaurus2 card.
The audio capture path is set separately in the capture Controls tab.
File Storage
Options : Broadcast WAV
Bit Depth
Options : 16 or 32
Number of bits per sample to capture.