User manual

DVO Grain
303
© 2014 Digital Vision
UM-2014.1-07
in the Setup section, use the Pos/Neg Trim control to adjust the noise
reduction levels equally for all RGB channels in highlights (Neg) or lowlights
(Pos).
Range :
0 to 7
Default :
0
Having a temporal strength of 7, setting up neg mode to neg and the
pos/neg trim to +2, will set the temporal strength to 7+2=9 for
highlights.
Processing is slower using trims. Even if Temporal/Spatial strengths
are at 0, Pos/Neg Trim will still add to this and result in processing
within highlights or lowlights.
Out Mix
This control is the same as the Out Mix control available in the basic mode
tab, and changes here are mirrored there.
Range :
0 to 7
Default :
0
Global Balance
Global Balance allows a combination of the basic level of spatial filtering and
motion adaptive spatial filtering.
Maximum filtering according to spatial strength is achieved in areas with
motion.
The Global Balance slider allows you to to set a minimum level of spatial
filtering, rather than having the level set entirely based on motion detection. If
the slider is set to 0, then parts of the image with no motion will receive no
spatial filtering. Increasing the slider increases the spatial filtering of areas
with little or no motion.
Range :
0 to 100
Default :
50
Motion Estimation
DVO Grain is a fully motion compensated noise/grain reducer. This means
that much more aggressive settings can be used without introducing
smearing.