User manual

Warper
232
© 2014 Digital Vision
UM-2014.1-07
The Warp 4 GUI controls
The Warp 4 GUI controls are shown above, and include separate sliders for
the X/Y movement of each Warp 4 control point. Four points leading to eight
sliders.
The Warp 9 GUI controls are similar but have eighteen sliders corresponding
to X/Y for all nine control points.
Warp 9-as-4
You can make the Warp 9 tool warp in a similar mode to Warp 4 by selecting
a corner point and dragging whilst holding down the ALT key :
Mouse drag top-right point :
Normal Warp 9 single point drag and warp
behaviour.
+ ALT :
Warp 9 warp behaviour with ALT held
down.
Note that the warper behaves in a
similar way to Warp 4 and as if the
mid-points do not exist. The central
point stays locked in place however.