User manual

Effects

200

UM-2014.1-07

The bold indicator in the effects tree signals that the effect has been

edited, not that the effect is active. User effects can be active by

default and will not appear bold unless the effect parameters are

edited.

You can reset an effect back to its original parameters by selecting the effect,

so that it's highlighted, and pressing the

Reset Effect

button on the effects

toolbar. You can also reset an entire layer, which will recursively reset all the

effects within the layer.

Split Panel View

Hot key : CTRL + F4

When editing effects it can be useful to view the timeline, or the shot list, at

the same time as you're editing the effect parameters. You can do this using

the split panel view.

This will switch the composition editor display to an extended panel mode and

will split the tabs so that you have the 'timeline' and 'list' tabs available across

the top and the 'effects', 'tracker' and 'scene detect' tabs along the bottom:

You can then click on the tabs as normal to change the combination, e.g. to

view the shot list and effect parameters: