User manual

Stereo Multitrack
184
© 2014 Digital Vision
UM-2014.1-07
A Stereoscopic mode can be enabled on a per project basis. This allows both
the display and the grading of stereo left and right channels.
Setting Up Stereo
For stereo support, you need to :
1. Enable a project setting and
2. Choose your stereo mode (if using an interlaced DVI device).
DVS Centaurus II Licensing
You will need the DVS Centaurus II license option Multidevice to
use stereo multitrack mode SDI output. See the DVS Centaurus II
Video section of the Setup Manual for more information.
Project Setting
Stereo is enabled independently per project. To enable stereo on a project,
select the project on the main project screen and select the Stereoscopic
Output tick-box :
Application Preferences
Two modes of stereo channel output are supported, SDI video and
interlaced DVI.
SDI
Output of left and right stereo on SDI channels A and B through a DVS
Centaurus II video board.
You will need to enable your SDI I/O card via :