Specifications

8 Multi Axis Engraver Operating Manual
Locate the rotary axis cable that comes off the back of the MAX Engraver as shown in figure 2.3 below.
(Figure 2.3) The rotary axis cable
Connect the table cable and rotary axis cable to the back of the Vision Series 3 Controller as shown in figure 2.4 below.
The serial cable shown below is the connection to your PC. For more information on this, please see the Vision Series 3
Controller manual. Note: The rotary axis and serial cables are similar in size but they are a different gender. Make sure
that you plug the cables into the correct place.
(Figure 2.4) The Vision Series 3 Controller connections