Specifications

Chapter 3 - Operations 19
4) Press the Y jog buttons on the Vision Series 3 Controller to move the spindle towards the center of the object you are
engraving.
5) The distance between the bottom of the spindle and the object you are engraving should be approximately 1 1/2”. If
it is not 1 1/2“, loosen the height adjustment knob and raise or lower the clamping device. See figure 3.13 for height
distance.
(Figure 3.13) Setting the height adjustment
6) Adjust the verticle position of the clamping device. To do this, loosen the vertical movement adjustment knob as
shown below in figure 3.14.
(Figure 3.14) The vertical movement adjustment knob