Specifications

18 Multi Axis Engraver Operating Manual
Insert the pen into the V shaped opening in the side of the pen & medallion jig and tighten the clamp.
Special Shapes
Clamping special objects requires the use of an optional clamp such as the universal pin jig. Mount the universal pin jig
onto the clamping device as shown.
Open the clamping device wide enough to accommodate the pen you are trying to engrave. To do this, turn the vice
tightening handle counter clockwise to open the vise and clockwise to close the vice. Set the material on the clamp as
shown in figure 3.11 below.
(Figure 3.11) Mounting a special shaped object on the MAX engraver
Insert the pins into the holes in the jig that will allow you to tighten the vice. Once the pins are aligned, tighten the
clamp. Always center the parts for easy setup.
Rotary Engraving
Round Objects - Initial Setup
When setting up to engrave round objects, you must follow the instructions below:
1) Remove any flat engraving jigs that may be installed on the MAX Engraver.
2) Insert the rotary cones into the machine that will accommodate the round object you are engraving.
3) Insert the object you are engraving into the rotary cones and tighten the cones up on the object as shown in figure
3.12 below. To do this, turn the vice tightening handle counter clockwise to open the vise and clockwise to close the
vice. Note: Do not overtighten.
(Figure 3.12) Inserting a round object in the MAX Engraver