Specifications

12 Multi Axis Engraver Operating Manual
10) Vice Tightening Handle - Turning this handle clockwise will tighten the vice and turning this handle
counterclockwise will loosen the vice.
(Figure 3.1) The MAX Engraver components
See Figure 3.2 below
1) Gib Adjustment Screws - These screws are used to adjust any play that may appear in the base of the vice. These
are adjusted properly at the factory but can be adjusted for wear by the end user.
2) Tilt Adjustment Handle - This handle allows adjustment of the tilt of the vice.
3) Vice Slide Adjustment Screw - When loosened, this knob allows you to move the tilting vise assembly forwards or
backwards to align different angles on materials.
4) Height Adjustment Knob - This screw allow you to move the tilting vise assembly up or down to accommodate
different thickness materials.