Installation guide

Vision Engravers and Routers PRE-Installation Guide6

3 Express and VE-810

Vision Express and VE-810 Connections

On the rear of the Vision Express and VE810, there are three connection ports. The power port, the

Ethernet port and the remote on/off port for the optional Vacuum Chip Removal System.

Vision Express (rear view)

For the Vision Express: Connect the power supply cable to a 110 - 220 VAC source, then connect the

power supply plug into the port on the back of the machine. Plug the Ethernet cable into the Ethernet

port.

Vision VE810 (rear view)

For the VE810: Connect the power cable to a 110 - 220 VAC source, then plug the power cable into the

port on the back of the machine. Plug the Ethernet cable into the Ethernet port.