Operating instructions

Page 5
A、When the source is HDMI1.3, (e.g., HDMI output from PS3), OUTPUT1
to 4 both support HDMI1.3 displays, meanwhile the RJ45 is not connected
to output port and is not connected to the input port, press "selection of
OUTPUT1” and “lock key" simultaneously, the machine will output
HDMI1.3 signals.
B、When the source is HDMI1.3, (e.g., the HDMI output from PS3),
OUTPUT 1 to 4 are connected to the displays that can only support HDMI
1.2 MAX, or the RJ45 is connected to the output port, meanwhile the input
port should not be connected, press "selection of OUTPUT1” and "lock
key" simultaneously (no matter whether HDMI OUTPUT port is
connected to the display that supports HDMI 1.3 or not), it will output
HDMI 1.2 signals.
 NOTE: The method to reset the machine to default EDID setting: Disconnect the input
and output. Please press "selection of OUTPUT1” and “lock key" Simultaneously for at
least 3 seconds, and EDID of all the four input ports will be reset to the default setting.
The audio setting of the default EDID is stereo. It is suitable for TV sets.
9) DIP switch setting
There are three DIP switch on the PCB in the chassis. Below is the
definition for the switch.
Position ID
1 2 3
UTP output mode and EDID
0 0 0 EDID mix mode (see note 1), Dual UTP mode
0 0 1 EDID mix mode,Single UTP mode (see note3)
1 0 0 EDID copy mode (see note 2), Dual UTP mode
EDID copy mode, Single UTP mode
 NOTE 1: EDID mix mode: This is the default mode. In this mode, when you press
"selection of OUTPUT1” and "lock key" simultaneously, the matrix will do the
SOURCE-SINK AUTOFIT function.
 NOTR 2: EDID copy mode: When you "selection of OUTPUT1” and "lock key"