Instruction manual

4
•Step 4.
Connect the glass engraver to the system control unit as shown in figure 1.2. If you already own
a Phoenix engraver, connect the gray “table” cable to the A/B box as shown in figure 1.2a.
Ensure that all of the connections are solid by screwing down the cable screws.
NOTES: (1) You have the option of designating which system will be the “A” device. It is recom-
mended that you assign the “A” to the system that you will operate the majority of the time. (2) If
your computer has only one parallel port and it is being used by your printer, you need to discon-
nect the printer cable, plug in the software key and plug the printer cable into the software key.
•Step 5.
Connect the recirculating pump power supply to the suge protector that was included with the
controller as shown in figure 1.2.
•Step 6.
Mix 1-gallon tap water with 1-2 tablespoons of cutting oil. It is recommended that only 1/2 gallon
be added to the holding tank, raising the level above the brass drain holes located on the outside
lower corners of the unit. At this time inspect for any leaks before proceeding. If no leaks are
found, add the remaining 1/2 gallon mixture. Ensure that the liquid level reaches above the
recirculating pump intake filter, approximately 1-1.5" deep. Add additional water as necessary.
•Step 7.
Power up the serial controller by flipping the “ON/OFF” switch in the rear. Allow 10-15 seconds
for the internal CPU to boot. Make sure that the emergency STOP button is NOT engaged, then
hit the “Drives On” key.
Figure 1.1 • Stylus with
packing material
(Front View)
Tail Stock
Head Locking Screws (4)