Instruction manual

14
Figure 3.3•The wine bottle adapter
maximum engraveable area for a large graphic or message or you can protect the label from the
coolant liquid. Simply wrap the label area with plastic wrap (Saran Wrap), and use masking tape to
secure the ends. This will keep the label dry during cutting. It will also keep the rub n’ buff off of
the label when applying.
Securing a wine or champagne bottle is no more difficult than securing a mug. Remove the splash
guard on the right side of the unit by removing the two thumbscrews that secure it in place. This
allows you to extend a bottle through the opening. Use the adapter as shown in fig 3.3. There is a
reversible insert in the bottle attachment that allows the user to hold bottles with various neck
diameters. Simply pull the insert out and rotate 180° and re-insert.
Hint: Over tightening the bottle may damage the lead protective sleeve at the neck of the bottle.
It may be helpful to place some tape over the area to avoid crushing the sleeve. Also, bottles have
many different neck sizes and all may not fit snugly into the adapter. Again, a little masking tape may
help to fill the void and allow for proper securing of the bottle.
Insert