Installation Guide

Z-Wave Command Classes:
COMMAND_CLASS_APPLICATION_STATUS
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V3
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_BATTERY
COMMAND_CLASS_CONFIGURATION_V4
COMMAND_CLASS_DEVICE_RESET_LOCALLY
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V5
COMMAND_CLASS_INDICATOR_V3
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V3
COMMAND_CLASS_NOTIFICATION_V8
COMMAND_CLASS_POWERLEVEL
COMMAND_CLASS_SECURITY
COMMAND_CLASS_SECURITY_V2
COMMAND_CLASS_SENSOR_MULTILEVEL_V11
COMMAND_CLASS_SUPERVISION
COMMAND_CLASS_TRANSPORT_SERVICE_V2
COMMAND_CLASS_VERSION_V3
COMMAND_CLASS_WAKE_UP_V2
COMMAND_CLASS_ZWAVEPLUS_INFO_V2
Z-Wave S2 Support Command Class:
COMMAND_CLASS_APPLICATION_STATUS
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V3
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_BATTERY
COMMAND_CLASS_CONFIGURATION
COMMAND_CLASS_DEVICE_RESET_LOCALLY
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V5
COMMAND_CLASS_INDICATOR_V3
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V3
COMMAND_CLASS_NOTIFICATION_V8
COMMAND_CLASS_POWERLEVEL
COMMAND_CLASS_VERSION_V3
COMMAND_CLASS_WAKE_UP_V2
Configuration – Temperature
Size
VALUE
Default
Parameter 1
1
°C
0x00
°C(0x00)
°F
0x01
Parameter 2
1
1~50 (Set up from
0.1°C~5°C)
3 (°C)
Configuration – Humidity
Size
VALUE
Default
Parameter 3
1
1~50 (Set up from
1%~50%)
20%
Configuration – Light
Size
VALUE
Default
Parameter 4
1
0,5~50 (Set up from 0
for Off or 5%~50%)
25%
Configuration – Motion Sensor:
Size
Value
Parameter 5
1
1 ~ 127 (unsigned decimal) Minutes
(default: 3 minutes)
Parameter 6
1
1 ~ 7 levels sensitivity,
(default: 4)
(Parameter 5) Re-trigger duration: User can change value from 1 to 127 minutes to
setup the re-trigger time when there is no movement detected in the period of time.
Default is 3 minutes.
(Parameter 6) Infrared sensor sensitivity adjustment, 7 levels sensitivity, 1 = most
sensitive, 7 = most insensitive, default values= 4
Configuration – LED Mode:
Size
Value
(Default: Mode 1)
Parameter 7
1
1 ~ 3 (Mode 1 ~ Mode 3)
Mode 1  LED Turn Off (Both Temp/PIR Trigger)
Mode 2  LED Quick Flash (Temp. / PIR Trigger)
Mode 3  PIR Trigger (Quick Flash)
Temp. Trigger (LED Off)
- 3 -
- 4 -