Assembly Instructions

ManualsBrandsVision ManualsOutdoorsOutdoor Vinyl Storage Shed

Panel Assembly – General Instructions

Vision Shed Wall Panels, Roof Panels and Corner Posts make

assembling your building easy. Each panel and post is engineered the

same way: Integrated Vinyl Channel Locks are integrally molded the

full length of the panels and are simply “snapped together,” locking the

pieces securely to create incredibly sturdy walls and roof.

Along each long vertical edge of the Wall Panels is either a DEEP or

SHALLOW Channel lock. The DEEP Channel lock should be facing

out toward the outside of the shed when installed, which means the

SHALLOW Channel lock, when installed, would be facing toward the

inside of the shed.

On a clean at surface, such as the shed base or level ground,

prepare to join two wall panels together by positioning one with the

DEEP Channel lock facing up and the other panel with SHALLOW

Channel lock facing down. Align the two channels, and then, starting

at one end, press down on the channel connection with the heel or

your hand or strike moderately with a rubber mallet. You’ll hear a click

sound as the seam between the two panels becomes ush. Continue

using the rubber mallet to engage the channel locks the full length

of the two panels. Add another panel to the wall section on the at

surface in a similar fashion making sure that the DEEP Channel lock

is mated to the SHALLOW Channel lock.

NOTE: If you mistakenly connect two DEEP Channel locks or two

SHALLOW Channel locks together, you can disengage them by gently

striking the short end of one of the two wall panels until it extends 2 to

3 inches beyond the other, and with a partner, slide each panel away,

lengthwise from one another, until fully separated. Turn one of the

channels over and engage the DEEP and SHALLOW channel locks

together as previously described.

Front, Back and Side Wall Assembly

Parts Needed:

4 Corner Posts 12 Back Wall Panels

4 Front Wall Panels 1 Lentil

20 Side Wall Panels 1 Door Header

(Right and left are determined when facing

the front of the building.) It’s helpful to lay

out all the required panels on the ground

around your foundation in their proper

sequence. Note that the back wall panels are

angled at the top edge and vary in length.

We recommend you begin the wall assembly

starting with the narrow wall section left of the

door opening and working your way clockwise

around the perimeter of the shed, ending at

the narrow wall section to the right of the door

opening.

Left

Right

Front

INCORRECT ASSEMBLY

Do not connect “like” channel locks (deep-

to-deep or shallow-to-shallow) when joining

panels together as this will result in improper/

unsafe construction. See NOTE at left.

CORRECT ASSEMBLY