Assembly Instructions

Ridge Cap

With both you and your assistant standing on ladders at

each end of the roof, position the ridge cap over the ridge

beam making sure each end is ush with the outer edge of

the outermost roof panel. With the rubber mallet, strike the

top of the ridge cap nearest the edge of the roof so that its

tabs seat on the vertical member of the ridge beam. You’ll

hear a characteristic click when it engages. Continue toward

the center of the roof in a similar fashion. Next have your

assistant follow the same steps from his/her side of the roof.

You’ll know the ridge cap is fully installed when there are no

gaps between the ridge cap and the roof panels.

Steel Reinforcement Slats

Insert three steel reinforcement slats on each both sides

of the exposed roof panel edges. Space the three slats as

evenly across the roof line as possible into the slots created

by the joined channel locks of the roof panels. Insert all the

way. Caution: the slats may work their way out until you

attach the Roof Fascia caps.

Roof Fascia Caps

Attach the Roof Fascia Caps over the exposed edge of the

roof panels, making sure the ends of the caps are ush with

the end of the front and rear roof fascia. Install #8 x 1" pan

head screws on the underside of the Roof Fascia Cap to

secure it to the roof panels. The screws should be installed

at every seam where the channel locks were engaged during

assembly.

Gable End Caps

Install the Ridge Beam End Caps by removing the backing

from the double-sided foam tape from the inner side of the

cap and positioning over the front and rear fascia gables and

ridge beam. Press to fully adhere foam tape.