User manual

9 Debian Installation
9.6. Partition Disks
After scanning your target storage media, you’ll be asked to continue with partitioning (see Figure
26). Answer with ’Yes’. In the second dialog select ’Guided - use entire disk’ as in Figure 27.
Figure 26: Partition Disks
Figure 27: Partitioning Method
In the next dialog confirm your target disk and then select ’All files in one partition’ scheme as in
Figure 28.
Select ’msdos’ for partition table type as in Figure 29
You’ll get the following partition table as in Figure 30. It is very important that you leave swap
partition during the installation. You can then change your partitions so you have only one partition
and swap as a swap file (see Section 3.6). Select ’Finish partitioning and write changes to disk’. In
the next dialog select ’Yes’ to format both partitions.
After doing this select ’Finish partitioning and write changes to disk’. In the next dialog select
’Yes’ to format both partitions.
May 2014 OnRISC User Manual 64