User manual

8 BIOS for KS8695 based Devices

8. BIOS for KS8695 based Devices

BIOS (Basic Input Output System) lets you conﬁgure your OnRISC e.g. conﬁgure how to boot,

set up date, time and so on. To get into the BIOS, press ’ESC’ during the system start and you’ll

enter the following menu (see Figure 5).

Figure 5: BIOS: main menu

To connect to the BIOS via Telnet press reset push button for a while till WLAN LED turns on

and the following output appears (see Figure 6). Now you can connect to the BIOS via network

by using the IP address speciﬁed under “Conﬁgure Network Parameter” (see 8.4).

Press ’Esc’ to enter setup or ’Tab’ for a bootlist

Figure 6: BIOS Prompt for Bootlist

May 2014 OnRISC User Manual 51