Instructions / Assembly
• Place the Gas Tank Caddy between
the rear legs of the grill cart (Step 1a).
• Fasten mounting brackets to cart
by removing nut and bolt from each
bracket, separating the top bracket
piece from Gas Tank Caddy frame.
Visit
www.visiongrills.com/register
to register your grill and
view frequently asked questions
Step 1: Install Gas Caddy to Grill Cart
• Slide Gas Tank Caddy under Cart, so top
bracket piece rests on cart frame and is
lined up with bolt hole on bottom of Gas
Tank Caddy.
• Reinsert bolt into frame and tighten
together with nut (Step 1b).
• Use the provided wrench to tighten all
connections.
• Attach the two hose brackets (used to hold
gas hose), with eyelets facing in, onto the
front and rear legs of cart (Step 2).
Note: Do NOT allow the hose to touch
the ceramic.
STEP 1a
STEP 1b
STEP 2
• Make sure the cylinder valve is closed (turn valve clockwise until tight).
• Inspect valve connections, port, hose and regulator assembly for any
damage or debris. Remove any debris.
• When connecting regulator
assembly to the valve, hand
tighten the quick coupling
nut clockwise to a complete
stop (Step 3b).
• After the gas hose is
connected to the gas tank
and Gas Insert, open valve
from gas tank and use some
type of leak test* method to
test the connection.
STEP 3b
Watch For Bubbles
*Leak Test:
Pour Leak Test Solution (not included)
or soapy water at the connection spot
of the gas cylinder to check whether
there is gas leakage. If solution produces
bubbles this means there is a leak.
STEP 3a
PARTS
• Put the gas tank on the Gas Tank Caddy
and tighten into place using Gas Tank Caddy
knob (Step 3a).
• From rear of grill, feed gas hose through
eyelets of the hose brackets, grill connector
rst. Connect gas hose to the Gas Insert
using the Quick Disconnect tting.
Step 2: Attach Hose Brackets
Step 3: Install Gas Tank
1
3
4
4.1
6
6.1
6.2
7
2
5
PART NAMES PART NUMBERS
1 Lava Stone
2 SS Stone Bracket
3 Infrared Heat Exchanger
4 Gas Grill Burner Insert
4.1 Gas Grill Burner Insert Knob
4.2 Ignition Button Cap
5 Gas Supply Line w/ Regulator
6 Gas Tank Caddy
6.1 Gas Tank Caddy Knob
6.2 Gas Tank Caddy Rubber Wheel
7 Gas Supply Hose Bracket (x2)
VGK-101R
VGK-BRACKET
VGC GPIHE
VGC GPBI-S
VGC GPBIK
VGC GPIBC
VGC GPSLR
VGC GPTC-SS
VGC GPTCK
VGC GPCWHL
VGC GPGSLC-2
4.2
• Remove Ignition Button Cap by
turning counter clockwise. Insert AA
battery (not included) negative end
rst.
• Replace Ignition Button Cap by
tightening clockwise.
• Press Red Ignition Button and hold
in to test battery. This will create
spark on burner for starting (See
manual for starting operation).
WARNING: To avoid shock, do not touch spark on burner
Step 4: Install Battery
STEP 4
+
–
SET UP
ENGLISH
KAMADO Quickchange Gas Insert
for S-Series Kamado Grills
Model # VGK-GPAK-S2
Patent Pending