Use and Care Manual

MAINTENANCE & TROUBLESHOOTING
1) After grill has cooled use a soft cloth to clean exterior of grill. 2) Clean the cooking grates before and after cooking. Note: Remove surface dust and grease 3) Stainless steel heat deector should be clean prior to each use. a) Check out if there is debris in the heat exchanger. b) When there is debris, please clean it with a stiff brush. 4) Clean Side Shelves with mild detergent. 5) When grill is cooled, use grill cover to prolong life of grill. 6) When the Gas Insert is not in use: a) Ensure that the Control Knob is off. b) Ensure that the valve on gas tank is turned to Closed position. c) Ensure that there is not gas leakage from the gas hose. 7) Leak Detection Method
a) Inspect valve connections, port and regulator assembly. b) Look for any damage or debris. Remove any debris. c) Inspect hose for damage. d) Turn gas cylinder knob clockwise to Open position. e) Pour soapy water or Leak Test Solution (sold separately) at the
connection spot of the gas cylinder to check whether there is gas leakage.
NOTE: Check whether bubbles appear. (If there are no bubbles, there
is no air leakage; If bubbles appear, there is gas leakage.)
f) Repeat Leak test at the connection spot at the gas entrance of the
gas insert to check whether there is gas leakage.
g) If you can not solve your problem by the above steps, or you
have other problems that need help, please contact Vision Grills Customer Service at [e-mail] or www.visiongrills.com.
1. Put match in the ignition tool
as shown.
2. Light match, insert inside the
front left opening as shown.
3. Slide in match to the inside
back of the Gas Insert, reaching the burner.
(Rear Side View shown) 4. Turn the knob to High and
press it down until it is lit.
5. Light the gas and observe
ame within the Heat Exchanger.
Manual Ignition (Match Ignition) Method of Operation
Watch For Bubbles
1 2 3 5 4