User manual

PTZ control panel provides 8-direction control. Move the cursor to the button of the desired direction then

click and hold the left mouse button to perform the desired turn. When the button is released, the turn will

stop. Some dome cameras may support only 4 directions, i.e. up/down, right/left. Check with the vendor in

advance to make sure that the desired functions are operable.

Iris, Focus, Zoom Control

Move the cursor to the desired control button and hold the left mouse button to perform the desired operation.

When the button is released, the action will stop. The circles to the right of Iris and Focus are used to activate

the “auto-iris” and “auto-focus” control. Some dome cameras may not support these functions. Users need to

check with vendors in advance.

Preset point function and its setup.

Only dome cameras support the

Preset

function. Click the

Preset point button on the PTZ control panel. The

camera will immediately move to the preset point. Depending on the type of dome camera, there are two

different numbers of preset points, i.e. 8 and 16. To set the preset points, move the camera to the desired

position then click the

Set preset

button on the PTZ control panel. Enter the

Set Preset of Dome Control

screen.

Click to hi-light the respective preset point. As in the example illustrated above, select a preset point. Enter

the name and click the

Save preset

button. This will finish the setup.

Note: The way to set PIH717X is slightly different. For example, to set the third preset point, first click the

button of the third preset point on the PTZ control panel then move the camera to the original third preset

point. (Use the direction, focus, and Zoom buttons to move the camera to the new preset point). Finally, click

the

Set preset

button on the PTZ control panel and enter into the Set Preset of Dome Control screen.

The Cruise Function

And Setup

The

CamSS

Programs supplemental function, i.e. “Cruise”, will be available after finishing the preset point

setup. Cruise allows the cameras to immediately move in a user-defined sequence and to define the camera

stay-time at each point. Click the

Setup button to the right of the

Cruise

button on the PTZ control panel to

enter into the

Cruise Setup

screen: