User manual

77
There are four repeat modes with the alarm schedule: Only Once , Every day , Every Week, and Every
month .
1. Adding a new alarm schedule
First, select the desired repeat mode. Then, enter the start/end day (week) and time into the boxes to the right
of the From and To fields. It can be entered directly, or click the arrows to the right of the fields, then click
the Add button to add a schedule to the list.
Note: If the time to be set crosses 12:00 midnight, it is recommended that the schedule be split into two, e.g.
Split PM6 :00:00~AM9:00:00 into “PM6:00:00~PM11: 59:59” and “AM12:00:00~AM9:00:00”.
2. Deleting a schedule
Click the desired schedule then click the Delete button to delete a schedule.
3. Deleting all of the schedules
Click Clear all to delete all of the schedules.
4. Closing the schedule window
Click the Close button or to exit the window.
Enable video recording after Mask areas are touched
An object intruding into the motion detection area where its alarm function is active will cause the recording to
begin. The detection area setup can be found on “recording windows” or “monitoring window”. The relations
of the alarm functions and recording functions are listed in the table below: