User manual

41
Chapter 4: Recording
4.1 Recording Windows
The CamSS system applies S uper M otion I mage C ompression T echnology ( SDMCT ) to compare two
continuous images. Even with alterations between these two images CamSS will, to a certain extent, perform
the functions of recording and triggering of related alarms. If there is no change in these two images, CamSS
can record on a fixed schedule that will enable the compression of the image files to be done at an even higher
compression ratio. This will reduce the needed hard disk space and extend recording time. The camera
recording windows may be activated at any time by clicking the Recording button in the CamSS Main Screen
in either of the following two ways:
Activate Recording of All Cameras
Clicking on the red round button on the upper right corner of the screen (as illustrated above) will open all of
the windows and will begin the recording process of all of the cameras.
Inactivate Recording of All Cameras
All of the windows may be closed and the recording of all cameras may be stopped by clicking the blue square
button on the upper right corner of the screen (as illustrated above).
Camera States.
The camera is not recording yet and is idle: