User manual

28
Adding A New Server: This is primarily to connect to a remote server. First, give a name to the server. Next,
choose Server from Type field. Then type the IP address into the Phone No./IP field. Finally, click the OK
button to finish the setup. (As seen below):
Adding a Remote IP : The address book is used to transmit an alarm message to the remote CamSS system
via LAN or Internet when an alarm is triggered. First, enter the name of the remote CamSS . Then select
Remote IP on the Type pull-down list. Click OK to finish the setup.
Adding A Modem: This is used for modem communication including remote access and remote alarm. Enter
the name of the modem then select Modem on the Type pull-down list. Input the remote CamSS system’s
phone number. Click OK to finish the setup.