Instruction manual

Installing In-Sight

5000 Series Vision Sensors

Precautions

Observe these precautions when installing In-Sight 5000 series vision sensors to reduce the

risk of injury or equipment damage:

• In-Sight 5000 series vision sensors are intended to be supplied by a Listed, Direct

Plug-In Power Unit with a minimum output rated 24VDC, 500mA and marked Class

2, Limited Power Source (LPS). Any other voltage creates a risk of fire or shock and

can damage the In-Sight components.

• Do not install In-Sight 5000 series vision sensors where they are directly exposed to

environmental hazards such as excessive heat, dust, moisture, humidity, impact,

vibration, corrosive substances, flammable substances, or static electricity.

• To reduce the risk of damage or malfunction due to over-voltage, line noise,

electrostatic discharge (ESD), power surges, or other irregularities in the power

supply, route all cables and wires away from high-voltage power sources.

• Maximize ESD protection by grounding the In-Sight 5000 series sensor case.

• Do not open the In-Sight 5000 series vision sensor or remote head camera. These

devices do not contain user-serviceable parts.

• Do not make electrical or mechanical modifications to In-Sight components.

Unauthorized modifications may violate your warranty.

• Changes or modifications not expressly approved by the party responsible for

regulatory compliance could void the user’s authority to operate the equipment.