Instruction manual

Installing In-Sight

5000 Series Vision Sensors

• Default Gateway: Specifies the IP address of the gateway host, if available on the

network. The gateway host is responsible for sending and receiving data between

hosts on different networks.

• DNS Server: Specifies the IP address of the host on the network providing DNS

resolution, if available.

• Domain Name: Specifies the network Domain for the host network.

• DHCP Timeout: Specifies the time an In-Sight sensor will wait for a DHCP server to

respond with an available IP address, when the sensor is configured for DHCP. If

the sensor times out, network communication is suspended. The sensor does not

attempt to connect to the network again until the power is cycled on the sensor.

• Telnet Port: Assigns the telnet port on which the active In-Sight sensor (a TCP/IP

server waiting for communication) listens for incoming requests from a remote

device (a TCP/IP client that initiates communication). A valid port assignment is any

unused number between 1 and 65535, excluding 21, 68, 80, 502, 1069, 1070, 1212,

2222, 44818 and 50000 (reserved for In-Sight communications).

• EIP I/O Watchdog Timeout Action: Specifies the In-Sight Ethernet/IP implicit

connection timeout behavior.

This completes the basic installation procedure for adding an In-Sight 5000 series sensor

onto a network using In-Sight Explorer. For information on using your sensor, refer to the

In-Sight Explorer

Help file.

NOTE:

The options available in the Network Settings dialog depend on the sensor type and firmware

version loaded on the sensor.