Instruction manual

Installing In-Sight
®
5000 Series Vision Sensors
27
9. In the Set Network Configuration dialog (Figure 4-4), select the first option, “Use The
Following Network Settings For All Sensors”.
Figure 4-4: Set Network Configuration Dialog
10. Enter values for the Subnet Mask; these settings will be applied to every sensor. The Subnet
Mask specifies which parts of the sensor's IP address are the same for all hosts on the local
network and which are unique to each host. Consult your network administrator for more
information.
11. Optionally, enter values for the Default gateway, DNS server and Domain; these settings will
be applied to every sensor.
• Default Gateway: Specifies the IP address of the gateway host, if available on the network.
The gateway host is responsible for sending and receiving data between hosts on different
networks.
• DNS Server: Specifies the IP address of the host on the network providing DNS resolution, if
available.
• Domain: Specifies the network Domain for the host network.
12. Click Next.