Instruction manual

Configuring the Sensor

7. In the left-hand text box, enter the MAC address for the sensor you would like to configure,

then click Add (

Figure 4-3). Repeat these two steps for any additional sensors you would like

to configure. Alternately, you can simply cycle power on any sensors you would like to

configure, and the In-Sight Connection Manager will automatically add the corresponding

MAC address to the list after the sensors reboot.

8. Click Next.

Figure 4-3: In-Sight Vision Sensor Dialog

NOTE:

The MAC address is located on the serial number label affixed to the sensor. This identifier is

factory-assigned, unique for every In-Sight sensor and cannot be changed or deleted.