Instruction manual

Installing In-Sight
®
5000 Series Vision Sensors
19
7. Restore power to the 24VDC supply. The green power LED on the sensor and the +24V LED
on the Expansion Module indicate that the sensor is receiving power
.
Figure 3-9: Connecting +24VDC and Ground Wires
!
CAUTION: Never connect the 1460 I/O Expansion Module to a power source other than
24VDC. Any other voltage creates a risk of fire or shock and can damage the
hardware. Do not connect the 24VDC source to any terminals other than the
2 pin 24VDC power connector.