Instruction manual
Installing the Sensor
18
3. Optionally, connect the DB9 male connector of an RS-232 serial cable to the corresponding
DB9 female connector on the Expansion Module (
Figure 3-7).
4. Plug the I/O Module Cable’s DB15 male connector into the corresponding female connector
on the Expansion Module.
Figure 3-7: Connecting the I/O Cable and Serial Cable
5. Plug the M12 connector of the I/O Module Cable into the sensor’s 24VDC connector (Figure
3-8).
Figure 3-8: Connecting the Expansion Module to the Sensor
6. Plug wire leads from a 24VDC supply for the +24V power and ground into the 2 pin terminal
plug labeled “Camera Power” on the Expansion Module (
Figure 3-9).
NOTE:
The I/O Module’s standard components do not include an I/O module cable; it must be
purchased separately.