Instruction manual

Installing the Sensor
16
3.2 Connecting the Model 1350 Breakout Module
The optional Model 1350 Breakout Module (P/N 800-5743-1/800-5743-1R) is a convenient
method to connect the sensor’s power, serial communications and I/O lines.
Figure 3-5: Breakout Module Connections
To Connect a Model 1350 Breakout Module to the In-Sight Sensor:
1. Verify the 24VDC power supply being used is switched off.
2. Optionally, connect the power and ground wires for the acquisition trigger input and the
discrete outputs to their corresponding terminals on the Breakout Module.
3. Optionally, connect the DB9 male connector of an RS-232 serial cable to the corresponding
DB9 female connector on the Breakout Module.
4. Plug the DB15 male connector of the I/O Module cable into the corresponding female
connector on the Breakout Module.
5. Plug the M12 connector of the I/O Module cable into the sensor’s 24VDC connector.
6. Plug the wire leads from a 24VDC supply for the +24V power and ground into the 2 pin
terminal plug on the Breakout Module.
7. Restore power to the 24VDC supply. The green power LED on the sensor and the orange
+24V LED on the Breakout Module indicate that the sensor and Breakout Module are
receiving power.
NOTE:
The Breakout Module’s standard components do not include an I/O module cable; it must be
purchased separately.