Instruction manual

Installing the Sensor
14
Connecting the Network and Breakout Cables
The sensor has an ENET connector and 24VDC connector. The ENET connection provides
the Ethernet connection for network communications. The 24VDC connection supplies
connections for the 24VDC power source, I/O, acquisition trigger, and serial
communications.
1. Attach the male M12 connector of the Ethernet cable to the sensor’s female M12 ENET
connector (Figure 3-3).
Figure 3-3: Connect the Network Cable
2. Connect the RJ-45 connector of the Ethernet cable to the PC, switch, or router, as applicable.
NOTE:
The In-Sight sensor standard components do not include a Breakout cable or Network cable;
these cables must be purchased separately.