Instruction manual

62 / 69
Copyright © 2012 TOSHIBA TELI CORPORATION, All rights reserved.
http://www.toshiba-teli.co.jp/index.htm
D4211908A
UserSetControl
This section describes UserSetControl category for the Bees GigE series.
You are able to save a user setting to the non-volatile memory of the camera. There are three user memory
banks for user setting.
By using user memory, you are able to restore frequently used settings at the time of next start-up.
The following table is the list of registers applied by “UserSetLoad”/“UserSetSave”.
Table. The register list applied by “UserSetLoad”/“UserSetSave”
Category Register Category Register
Width TimerDuration
Height TimerDelay
OffsetX
CounterAndTimerControl
TimerTriggerSource
OffsetY Gain
BinningHorizontal GainAuto
BinningVertical BlackLevelSelector
ImageFormatControl
PixelFormat BlackLevel
AcquisitionMode
AnalogControl
Gamma
AcquisitionFrameRate Teli_ALCReferenceLuminance
TriggerMode Teli_ALCExposureValue
TriggerSource Teli_ALCTolerance
TriggerActivation Teli_ALCThrottle
TriggerDelay Teli_ALCExposureTimeMin
ExposureMode Teli_ALCExposureTimeMax
ExposureTime Teli_ALCGainMin
AcquisitionControl
ExposureAuto
ALCControl
Teli_ALCGainMax
LineInverter UserSetControl UserSetDefaultSelector
DigitalIOControl
LineSource
● Registers
Register Visibility Access Description
UserSetSelector Beginner R/W Selects a bank of user setting.
UserSetLoad Beginner W Executes load of the user setting.
UserSetSave Beginner W Executes to save the user setting.
UserSetDefaultSelector Beginner R/W Selects a bank of user setting when camera powers up.