Instruction manual

44 / 69
Copyright © 2012 TOSHIBA TELI CORPORATION, All rights reserved.
http://www.toshiba-teli.co.jp/index.htm
D4211908A
- Sets trigger delay (HardwareTrigger operation only)
Set the following value to “TriggerDelay” register. Setting value is Float type.
Adds delay time from trigger edge to exposure start.
setting value TriggerDelay[µs]
Minimum (*) 0.00[µs]
Maximum 4095.00[µs]
* initial factory setting
● Note
Changing “TriggerMode”, “TriggerSource”, “TriggerActivation” registers value is invalid during image stream
data output.
When SoftwareTrigger operation, the period from execution of “TriggerSoftware” to grab image is an
indefinite.