Instruction manual

43 / 69
Copyright © 2012 TOSHIBA TELI CORPORATION, All rights reserved.
http://www.toshiba-teli.co.jp/index.htm
D4211908A
● Registers
Register Visibility Access Description
TriggerSelector Beginner R Returns the type of trigger.
TriggerMode Beginner R/W Selects Random Trigger Shutter mode.
TriggerSoftware Beginner W Executes software trigger.
TriggerSource Beginner R/W Selects trigger source of Random Trigger Shutter.
TriggerActivation Beginner R/W Selects trigger polarity of hardware trigger.
TriggerDelay Expert R/W Sets trigger delay.
● Setting
- Selects trigger mode
Set the following value to “TriggerMode” register. Setting value is Enumeration type.
setting value Operation Mode
Off (*) Normal Shutter Mode
On Random Trigger Shutter mode
* initial factory setting
- Selects trigger source
Set the following value to “TriggerSource” register. Setting value is Enumeration type.
setting value Trigger source
Line0 (*) Hardware trigger
Software Software trigger
* initial factory setting
- Grabs image stream by software trigger
When executes “TriggerSoftware” register command, software trigger command is generated. And the
camera starts exposure by receiving software trigger command in software trigger mode
- Changes trigger polarity (HardwareTrigger operation only)
Set the following value to “TriggerActivation” register. Setting value is Enumeration type.
setting value Polarity
FallingEdge (*) Negative
RisingEdge Positive
* initial factory setting