Instruction manual

34 / 69

http://www.toshiba-teli.co.jp/index.htm

D4211908A

● Setting

- Set image size and image start position

Set the following value to “Width”, “Height”, “OffsetX”, “OffsetY” registers. Setting value is Integer type.

“Width”, “Height” registers are image size setting. “OffsetX”, “OffsetY” registers are image start position

setting.

Model BG030 BG031 BG080 BG130

Width unit size 160 160 256 160

Height unit size 120 120 192 120

OffsetX unit size 32 32 32 32

OffsetY unit size 24 24 24 24

Minimum unit size 160×120 160×120 256×192 160×120

Maximum unit size (*) 640×480 640×480 1024×768 1280×960

* initial factory setting

● Note

Changing “Width”, “Height”, “OffsetX”, “OffsetY” register value is invalid during image stream data output.

Notes on scalable mode:

White lines may occur in the upper portions of the screen when strong light exists in a wide area during the scalable

mode. This is not a malfunction. If white lines occur, adjust the amount of incident light using the lens.