Instruction manual

26 / 69
Copyright © 2012 TOSHIBA TELI CORPORATION, All rights reserved.
http://www.toshiba-teli.co.jp/index.htm
D4211908A
Timing Specification
Image data outputs of this camera series are transferred with the UDP protocol of Gigabit Ethernet. Timing
numerical value below is prescribed by absolute prerequisite that Bees GigE series use transmission band
without restriction of other node. When there is a node transferring with Bees GigE concerned, it is not same
the numerical value prescribed below.
● Image Stream Output (normal shutter)
T2T1
GbE bus
Expose
ImageImage Image
T
DLY1
T
T2
DLY2
Model T1 [ms] T2 [ms] Default Framerate [ms]
BG030 8.0
BG031 8.0
BG080 25.0
BG130
see following
formula.
same as
Frame Rate.
33.3
TDLY1: GVSP_BLOCK_START_DELAY
TDLY2: SCPD(Stream Channel Packet Delay)
* , T1 = 100µs or longer.
PayloadSize is total bytes of single frame.
The formula applies when SCPS (Stream Channel Packet Size) is 1500 byte / packet.
(T1 varies depending on the value of SCPS)