Instruction manual

16 / 69

http://www.toshiba-teli.co.jp/index.htm

D4211908A

Connector Pin Assignment

Rear View

1. Gigabit Ethernet Interface Connector

RJ-45 Jack

Pin No. I/O Signal Function

1 I/O BI_DA+ / VDC+ Bidirectional Data A (+) / Power (+)

2 I/O BI_DA- / VDC+ Bidirectional Data A (-) / Power (+)

3 I/O BI_DB+ / VDC- Bidirectional Data B (+) / Power (-)

4 I/O BI_DC+ / VDC+ Bidirectional Data C (+) / Power (+)

5 I/O BI_DC- / VDC+ Bidirectional Data C (-) / Power (+)

6 I/O BI_DB- / VDC- Bidirectional Data B (-) / Power (-)

7 I/O BI_DD+ / VDC- Bidirectional Data D (+) / Power (-)

8 I/O BI_DD- / VDC- Bidirectional Data D (-) / Power (-)

2. I/O Connector

Connector (Camera side) HR10A-7R-6PB(73) (HIROSE ELECTRIC CO., LTD.) or equivalency product

Plug (Cable side) HR10A-7P-6S(73) (HIROSE ELECTRIC CO., LTD.) or equivalency product

* This camera cable is not an accessory of this product.

I/O Connector pin assignment

※ Above figure is connector view from insert side.

Pin No. I/O Signal Function

1 I +12V Power

2 I Line 0 External Trigger Input

3 O Line 1 GPIO_0 Output (LVTTL)

4 O Line 2 GPIO_1 Output (Open Collector)

5 - I/O GND I/O_Ground

6 - GND Ground

1 6

3 4