User manual

Phantom Camera Control Application - Help 95

· If the camera is being clocked via another camera the delay MUST be set to a

minimum of 1µs greater than that defined in the clock source camera. or

· If a delay is required between the clock source pulse and the frame capture to provide

a phase shift in the timing.

This field MUST be defined when synchronizing multiple Phantom cameras using one

Phantom camera as the primary clock source.

Real Time Output

When enabled, checked, an image data will stream to an Image

Enable Box

When enabled, (checked), image data will stream from the selected camera to an attached

Image

Temperature

The Temperature informational fields indicate the operating temperatures of the selected

camera and its' sensor.

Cam:

This informational field displays the operating temperature of the camera.

NOTE

If the temperature of the Cam:, (camera), exceeds the camera's factory set threshold setting

the camera's cooling system will work harder to reduce the camera's operating temperature.

Sensor:

This informational field displays the operating temperature of the sensor.

NOTE

If the Sensors temperature rises above the sensor's factory set threshold setting, the

sensor's thermal expansion diodes will reduce the temperature of the sensor. If the sensor

temperature dips below the (sensor) factory set threshold setting, the sensor's thermal

expansion diodes will increase the temperature of the sensor.

Signals Button

The Signals button, when selected, opens the Analog and Binary Signal Acquisition dialogue

window used to define the parameters necessary for the Phantom Camera Control application

to process the signal information.

NOTE

This feature is not supported on the Phantom 65, HD, or Miro Series cameras.

Trigger

Rising/Falling Edge

When selected defines whether the leading edge or trailing edge of a TTL supplied

input trigger signal is to be used to trigger the camera. To select the leading or falling

edge click the Rising Edge or Falling Edge radio button respectively.

Filter Time (ms)

Filter Time instructs the Phantom camera to ignore a trigger signal if it is detected

before the specified Filter Time parameter. It also specifies the length of time the