User manual

Phantom Help File64
© 2010 Vision Research - An AMETEK Company
1)
Depress the Power On/Trigger button to apply a hard-trigger to the camera.
c.
Capture Cable Trigger Input Connector
1)
Provide a hard trigger to the camera by supplying:
a)
Dry switch closure, or
b)
A low TTL pulse signal.
Playback Operation
1.
Gently press on the Play selector in the LIVE CST Display Screen.
2.
Use the Playback controls to review recorded images:
Reverse; to double the reverse playback speed hold down for approximately 1
seconds.
Reverse 1 Image.
Forward 1 Image.
Forward; to double the forward playback speed hold down for approximately 1
seconds.
NOTE
To Pause the playback process, gently press slightly below the Memory Buffer Graphical
Representation Bar at the top of the display screen.
3.
Edit the record cine file:
a.
Gently press the Edit/Save selector.
b.
Locate the first frame the cine file is to begin with.
1)
Press a little below the Memory Buffer Graphical Representation Bar, then
2)
Hold down on the screen, and
3)
Scrub in the direction you wish the cine file to go, (right - backwards, left - forwards).
c.
Set the Mark In Point:
1)
Press the Set In Selector.
d.
Locate the last frame the cine file is to end with:
1)
Press a little below the Memory Buffer Graphical Representation Bar, then
2)
Hold down on the screen, and
3)
Scrub in the direction you wish the cine file to go, (right - backwards, left - forwards).
e.
Set the Mark Out Point:
1)
Press the Set Out Selector.
NOTE
To scrub through the cine file:
a.
Press slightly below the Memory Buffer Graphical Representation Bar, then
b.
Gently hold down on the screen, and