User manual

Phantom 65 or Phantom HD Control via "On-Camera" Control Buttons 331

When the camera is in the playback, PLAY CST, mode the Trigger button is used to play and/or

stop the playback of the recorded/stored cine file in reverse.

When running in Run/Stop Mode the camera will capture frames, (to the Phantom CineMag),

after the trigger is pressed once, and stops capturing when the trigger is pressed again.

Select Setup (Settings) Button

This button is used to select the camera,s set up and recording parameters. The camera's

parameters can be defined when the camera is in either the Pre-Trigger LIVE PRE (Preview,

Waiting for Pre-Trigger), and Capture, LIVE WTR (Preview, Waiting for Trigger), modes.

It also allows you to scroll through the cine file stored in the camera's DRAM image buffer and

the Phantom CineMag Flash memory for playback.

The Setup Select button can also be used to scroll through a recorded cine file to find images

that you wish to define as Mark-In and Mark-Out points of the file easily.