User manual

Phantom 65 or Phantom HD Control via "On-Camera" Control Buttons 325

This field indicates the active pixel area, (Width x Height), of the sensor defined by the user.

Sample Rate

This field specifies the rate the Phantom camera will capture or record image data, (frames), into

the camera's memory.

Shutter Angle

This field shows the current, user defined, Shutter Angle or exposure setting of the camera.

Memory Buffer Graphical Representation

The graphical representation of the camera's memory buffer, which acts as a memory gauge will

display a Mark In Point, (the vertical line on the far left of the line), and a Mark Out Point, (the

vertical line on the far right of the line). The Recording to Memory Location Indicator, (the up-

arrow), will be placed just below the Mark In Point. The trigger point, (T), indicates the image, or

frame, the trigger signal was sent to and detected by the camera.

Edited/Recorded Cine Duration

In this mode, the Maximum Recording Time field change from a single number to two. The first

number represents the duration of the cine contained within the Mark In and Mark Out points. The

second number represents the duration or length of the cine file stored in the camera memory

buffer.

Maximum Recordable Frames

This field indicates how many images or frames will be recorded within the Duration time. This

field will also change based on how the amount of memory in the camera, and how the resolution,

and sample rate are set and will change accordingly.