User manual

Phantom Help File196
© 2010 Vision Research - An AMETEK Company
4.2.5.3.7 Define the Trigger Settings
STEP-BY-STEP PROCEDURE
1.
Click the Live Control Panel Tab.
2.
Click on Advanced Settings, then
3.
Define the Trigger options:
a.
Enable, (check), Rising Edge to define the leading edge of a TTL supplied input trigger signal
to trigger the camera, alternatively
b.
Enable, (check), Falling Edge to define the trailing edge of a TTL supplied input trigger signal to
trigger the camera, then
c.
Enter a Filter Time value, in µs, to instruct the Phantom camera to ignore a trigger signal if it is
detected before the specified Filter Time. It also specifies the length of time the trigger signal
must be held in for it to be a valid trigger signal.
NOTE
The Trigger options are not available with Phantom v4.1, v5.0, or v6.0 cameras.
4.2.5.3.8 Define the Pretrigger Pin Is:
To specify if the TTL supplied input signal is to be used to toggle Memory Gate or as a pre-trigger
input signal.
STEP-BY-STEP PROCEDURE
1.
Click the Live Control Panel Tab.
2.
Click on Advanced Settings, then
a.
Click the Memory Gate radial button to use the shared Capture cable pin reference as the
Memory Gate Input signal, alternatively
b.
Click the pre-trigger radial button to instruct the camera to use the shared Capture cable pin
reference as the pre-trigger Input signal.
NOTE
The MemGate options are not available with Phantom v4.1, v5.0, or v6.0 cameras.